Transformations

After clicking on the Transformations tab on the property panel on the right, you will see a menu that displays the parameters for transforming cells of the selected type.

If the selected cell type in the diagram does not have transformations, then there will be no parameters available for editing on the Transformations tab.

In the figure above, the selected cell type in the diagram already has a transformation (), so under the Cell types field there is already a field with the name of the cell type (in this case, CellDefinition), into which the cells of the selected type are transformed. If the selected cell type in the diagram had several transformations, then there would be several such fields (a separate field for each transformation in the diagram).

For each cell type into which the selected cells are transformed, you can configure the Transformation rate parameter, which characterizes the transformation rate.

This parameter can also be configured directly on the model diagram.

Important

You should not add new transformations in the Transformations tab - add and remove them only through the diagram.